Posts by Mark123
Truckin Magazine does a 2010 GMC Sierra 4/7 kit
A Behind the Scenes look at Truckin Magazine as they Install A DJM Calmax Lowering Kit Truckin’ Magazine contacted us wanting to use our Calmax 4/7 kit on a 2010 GMC Sierra project. We were very happy to work with Jeremy Cook editor and Anthony Soos contributing editor while they installed our kit in their fantastic…
Read MoreFlatten Corners – DJM 4/6 Kit on a 94 C1500
“We knocked a full ten seconds off our lap time” “Lowering a truck’s center of gravity will allow it to carve through corners with less body roll” That’s what Bob Ryder with STREETTRUCKS Magazine said when describing this 94 Chevy C1500 ‘s transformation from stock to a blast to drive! Check out the original article below!!…
Read More1978 Ford F100
Man what a nice F100, just needs a couple things and it’s better than nice! Gerald Haney must have been thinking thoughts like this as he began the restoration of his 78 F100…
Read MoreEpisode 9 – Cylinder Head Rebuild Part 1
Episode 9: Cylinder Head Rebuild Part 1 The Shelby Daytona is down for an unexpected head gasket repair. Worse yet, once it was apart we found that the cylinder head had cracked in several places! Does this mean that our head is junk? Are we going to have to settle for a used head of…
Read MoreNew 2017 DJM Interactive Catalog
Here’s an interactive, e-catalog version of our New DJM 2017 Application Guide. Linked to the website providing more content for each part! Check out the images to get the most out of your catalog! You can download the entire 2017 Catalog here
Read MoreEpisode 8: Exploring Rod Knock
Episode 8: Exploring Rod Knock The boys are at it again, rescuing another old Ford out of the New England woods. This time, they’re stuck with a spun rod bearing. What is rod knock? Which rod is knocking? Matt and Steve will show you a simple test to find out which bearing has gone bad.…
Read More