1988 – 1999 C2500 / C3500 3 Inch Drop Spindles

A close look at our spindles will tell the story of precision machining resulting in ball joints & tie-rods properly positioned, quality meehanite castings machined as accurately as the 4142 Chrome moly spuds (axles) inserted into them. All of this adds up to a strong accurate part. It’s a fair amount of work to change your spindle don’t waste your effort with inferior spindles. Another smart thing to do at this time is to inspect and replace if necessary your wheel bearings, ball joints and take a good look at your tie rod end. Chances are they fine but if in your excitement you miss a worn bearing, well it’s a lot of labor to go back in and change it!

*8 LUG ONLY*

By the way you get a full 3″ of drop with your factory coils and you can use factory length shocks.

Shocks are NOT included with this kit. DJM recommends part:

• Shock number 1415